Application of Adaptive Neuro Fuzzy Logic Method of Noised Electrical Signals for Correction

Erol Can


In this article,    the correction of the distorted electrical signal with an adaptive neural fuzzy logic (ANFIS) due to noise forming in  is discussed. An electrical signal, such as a sinus signal, is widely used both in load supply and in modulation techniques for control and information transport. While the deterioration in the sinus structure causes energy losses, it also causes damage to the control and information transmission signals. Therefore, after considering the structure of the clear reference signal equation, a noise that may occur in the sinus structure is included in the clear reference signal structure. An interference signal must be formed with the unknown nonlinear process from another noise source for measuring of the information signal because of an interference signal needs. After an interference signal is generated, the measuring signal is given in the sum of the pure reference signal and the interference. For the correction phase of the signals, at inputs of the adaptive fuzzy logic system in the Matlab toolbox, the source signal with noise and the measuring signal values are entered and the experiment is performed via a 3-membership function.  When the results are observed, it is seen that the signal which is distorted after the correction operations is very close to the reference signal


noise forming, clear reference signal, sinus structure, ANFIS, energy losses, information transmission

Full Text:



Can, E. The modeling and analysis of a power transmission line supplied by a solar power plant. Tehnički glasnik, 12(3), 124-130, 2018.

Can, E. Analysis and Performance with Vertical Divided Multilevel Voltage on Phase of Induction Engine. Tehnički vjesnik, 25(3), 687-693, 2018.

Midya, R., Wang, Z., Asapu, S., Joshi, S., Li, Y., Zhuo, Y., ... & Lin, P. Artificial Neural Network (ANN) to Spiking Neural Network (SNN) Converters Based on Diffusive Memristors.Advanced Electronic Materials, 1900060, 2019.

Abu-Elanien, A. E. An Artificial Neural Network Based Technique for Protection of HVDC Grids. In 2019 IEEE PES GTD Grand International Conference and Exposition Asia (GTD Asia) (pp. 1004-1009). IEEE, 2019. DOI: 10.1109/GTDAsia.2019.8716021

Novak, M., Dragicevic, T., & Blaabjerg, F. Weighting factor design based on Artificial Neural Network for Finite Set MPC operated 3L-NPC converter. In 2019 IEEE Applied Power Electronics Conference and Exposition (APEC)(pp. 77-82). IEEE , 2019. DOI: 10.1109/APEC.2019.8722062

Şahin, M. Determining Optimum Tilt Angles of Photovoltaic Panels by Using Artificial Neural Networks in Turkey. Tehnički vjesnik, 26(3), 596-602, 2019.

Sahin, M. A New Approach For The Estimation Of Depreciation Factor And Energy Loss In Lighting System. Fresenius Environmental Bulletin, 28(5), 3787-3794, 2019.

Can, E. Mathematical Algorithm Of Fuzzy Logic Controller For Multilevel Inverter Creating Vertical Divided

Voltage. Acta Polytechnica,59(1), 1-11,2019. doi:10.14311/AP.2019.59.0001

Tarek, B., Said, D., & Benbouzid, M. E. H. (2013, March). Maximum power point tracking control for photovoltaic system using adaptive neuro-fuzzy “ANFIS”. In 2013 Eighth International Conference and Exhibition on Ecological Vehicles and Renewable Energies (EVER) (pp. 1-7). IEEE.

Andrew-Cotter, J., Uddin, M. N., & Amin, I. K. (2019, May). Particle Swarm Optimization based Adaptive Neuro-Fuzzy Inference System for MPPT Control of a Three-Phase Grid-Connected Photovoltaic System. In 2019 IEEE International Electric Machines & Drives Conference (IEMDC) (pp. 2089-2094). IEEE.

Benbouhenni, H., Boudjema, Z., & Belaidi, A. (2018). Neuro-second order sliding mode control of a DFIG supplied by a two-level NSVM inverter for wind turbine system. Iranian Journal of Electrical and Electronic Engineering, 14(4), 362-373.

Boudjema, Z., Taleb, R., Yahdou, A., & Kahal, H. (2015). High order sliding mode control of a DFIM supplied by two power inverters. Carpathian Journal of Electronic and Computer Engineering, 8(1), 23-30..

Barambones, O., & de Durana, J. G. (2015). Sliding mode control for power output maximization in a wave energy systems. Energy Procedia, 75, 265-270.

Shehata, E. G. (2015). Sliding mode direct power control of RSC for DFIGs driven by variable speed wind turbines. Alexandria Engineering Journal, 54(4), 1067-1075.

Jang, JSR., 1993. ANFISAdaptive‐network‐based neurofuzzynference systems. IEEE Transactions on Systems Man and Cybernetics, 20(03), 665–85. DOI: 10.1109/21.256541

Zindani, D., Roy, A. K., Kumar, K., & Davim, J. P. (2019). Fuzzy Logic for Machining Applications. In Advanced Fuzzy Logic Approaches in Engineering Science (pp. 341-361). IGI Global. DOI: 10.4018/978-1-5225-5709-8.ch016

Takagi, T., and Sugeno M. Fuzzy identification of systems and its applications to modeling and control. IEEE Transactions on Systems, Man, andCybernetics, 15, 116‐132,1985.

Amirian, M. (2019, April). Mitigating Sub-Synchronous Resonance Using Static Var Compensator (SVC) Enhanced with Adaptive Neuro-Fuzzy Inference Systems (ANFIS) Controller. In 2019 27th Iranian Conference on Electrical Engineering (ICEE) (pp. 532-538). IEEE.

Amin, I. K., Uddin, M. N., & Marsadek, M. (2019, May). ANFIS based Neuro-Fuzzy Control of DFIG for Wind Power Generation in Standalone Mode. In 2019 IEEE International Electric Machines & Drives Conference (IEMDC) (pp. 2077-2082). IEEE.



  • There are currently no refbacks.

Copyright (c) 2020 TECCIENCIA